Products-Ruixing Steel Pipe Manufacturing Co., Ltd.

Project for lightweight magnesium-aluminium alloy casing components for cold chain equipment in North America

A North American cold chain logistics equipment manufacturer faced the issue that the original steel body components were excessively heavy, increasing the vehicles’ fuel consumption.

View More +

Contact Us

Stainless Steel Alloy Piping Project for Water Pumping Stations in Africa

A water supply and irrigation pumping station in a rural area of Africa, where the groundwater contains high levels of silt, resulting in severe scouring and corrosion on the inner walls of the water supply pipes.

View More +

Contact Us

Project for Wear-Resistant Alloy Lining Plates for Conveyor Equipment at South American Mines

In an open-cast iron ore mine in South America, high-speed ore impact was causing rapid wear to the lining plates, and frequent production stoppages to replace them were affecting the mine’s output.

View More +

Contact Us

Project for Biphasic Alloy Impeller Components for European Wastewater Treatment Equipment

A municipal sewage treatment plant in Europe. The medium within the aeration tanks consists of acidic and alkaline corrosive effluent, causing severe wear and corrosion to standard stainless steel impellers, resulting in short replacement cycles.

View More +

Contact Us

Heat-Resistant Aluminium Alloy Project for Photovoltaic Mounting Systems in the Middle East

At solar power stations in the Middle Eastern desert, the ground surface is exposed to intense heat during the summer, causing standard steel mounting structures to oxidise and deform, which affects the installation accuracy of the solar panels.

View More +

Contact Us

Project for High-Strength Alloy Components for Port Cranes in South-East Asia

Project Overview: At a major freight port in South-East Asia, the existing crane boom connectors had long been subjected to corrosion from sea winds and salt spray, as well as impact from alternating loads. This resulted in rapid cracking and wear of the components, leading to persistently high maintenance costs.

View More +

Contact Us

Gr12 Titanium alloy plate

Gr12 titanium molybdenum nickel alloy nominal composition is Ti-0.3Mo-0.8Ni, is the mid-1970s in the United States research and development of Ti-12 alloy.

View More +

Contact Us

Gr12 Titanium alloy coil

Gr12 titanium molybdenum nickel alloy nominal composition is Ti-0.3Mo-0.8Ni, is the mid-1970s in the United States research and development of Ti-12 alloy.

View More +

Contact Us

Gr2 Titanium alloy pipe

Gr.2 is most widely used in chemical pressure vessels and seawater treatment applications.

View More +

Contact Us

Ti-6al-4v (TC4) Titanium alloy bar

Ti-6al-4v (TC4) titanium alloy is a duplex alloy, with good comprehensive properties, good microstructure stability, good toughness, plasticity and high temperature deformation properties, can be better hot pressure processing, quenching, aging to strengthen the alloy. The strength after heat treatment is about 50% ~ 100% higher than that after annealing.

View More +

Contact Us

Gr7 Titanium alloy tee

Gr7 alloy is mainly used in dilute hydrochloric acid, dilute sulfuric acid and dilute phosphoric acid environment. It is also widely used in titanium equipment to prevent crevice corrosion, such as tubular heat exchanger and spinning spinneret.

View More +

Contact Us

Ti-6al-4v (TC4) Titanium alloy flange

Ti-6al-4v (TC4) titanium alloy is a duplex alloy, with good comprehensive properties, good microstructure stability, good toughness, plasticity and high temperature deformation properties, can be better hot pressure processing, quenching, aging to strengthen the alloy.

View More +

Contact Us